Sliding line theory

The preparation of the trolley line before installation, as well as the confirmation of the system layout. In addition, some technical points and difficulties in the installation process are related to the installation of the trolley line and are necessary for this work. Theoretical knowledge. So, let's take some time to do a good job of explaining it.

1. The preparatory work slide line before the installation of the sliding line, before the installation, the preparation to be carried out, in particular, the main ones are as follows:

(1) The relevant mobile devices, as well as the tracks, etc., have been installed and have not been checked after inspection.

(2) The power supply cable and the outgoing cable of the mobile device have all been put in place.

(3) For the input, and the interface requirements of the collector, after checking and confirming, there are no problems and doubts.

(4) At the installation site, there are working platforms that can be used normally, as well as related technical and operational personnel. In addition, the construction materials and equipment used are all in place.

2. Confirmation of system arrangement in the trolley line For this, it mainly involves five, specifically the system as a whole, the expansion component, the fixed clamp, the power input unit and the maintenance unit. And, these five parts are indispensable. In its content, it mainly involves the number and location. For the system as a whole, love it, which is generally horizontal.

3. Some technical points and difficulties in the installation process of the sliding line

Technical points and difficulties 1: In general, the center line of the sliding line is parallel to the running track of the equipment. However, in practice, there may be a deviation phenomenon, so that the two are not parallel. Therefore, in this case, there is no straightness requirement, but an efficient operation method is selected.

Technical points and difficulties 2: For angle brackets, if the installation cannot be carried out according to the standard spacing, the installer should pay attention to the spacing between the joint jacket and the angle bracket, and whether it can meet the safety requirements of free telescopic. If it is not met, then some measures are needed to make adjustments to meet the requirements.